Guide on Resetting Service Required Message for EPSON L455

Reset Epson L455

If you own an EPSON L455 printer and you are facing a “Service Required” error message, don’t worry, there is an easy solution to reset your printer and get it back to its normal functioning. Here are the steps to reset EPSON L455 Service Required:

1. Start by turning off your printer and unplugging it from the power source. Wait for a few minutes before proceeding to the next step.

2. While the printer is off, press and hold the Resume/Cancel button on the printer’s control panel. Keep holding the button and press the power button to turn on the printer. Continue holding the Resume/Cancel button until the power LED starts flashing.

3. Once the power LED is flashing, release the Resume/Cancel button. Now, press the Resume/Cancel button four more times. After the fourth press, release the button and wait for the printer to stop flashing.

4. Finally, press the power button to turn off the printer. Wait for a few seconds, and then turn on the printer again. The “Service Required” error message should be gone, and your printer is reset successfully.

It is important to note that resetting your printer might also clear any custom settings you have made on your printer. Therefore, it is recommended to take note or screenshot your current settings before performing the reset.

By following these simple steps, you can easily reset the EPSON L455 Service Required error and continue using your printer without any issues.

|You are engrossed in the story: Reset Epson L455 at printerkeys.com

Download Epson L455 Resetter

– Epson L455 Resetter For Windows: Download
– Epson L455 Resetter For MAC: Download

Wicreset key

Fix Epson red lights blinking with errors: Service Required, A printer's ink pad at the end of its service life Please contact Epson Support.

How to Reset Epson L455

1. Read Epson L455 Waste Ink Pad Counter:

If Resetter shows error: I/O service could not perform operation… same as below picture:

==>Fix above error with Disable Epson Status Monitor: Click Here, restart printer/computer and then try again.
2. Reset Epson L455 Waste Ink Pad Counter

– Buy Serial Key:

Wicreset key

Fix Epson red lights blinking with errors: Service Required, A printer's ink pad at the end of its service life Please contact Epson Support.

3. Put Serial Key:

4. Wait 30s, turn Epson L455 off then on

5. Check Epson L455 Counter

#Extend your reading experience https://printerkeys.com/epson-l4263-l4266-l4267-l4268-l4269-software-adjprog-error-e-11-waste-ink-pad-counter-reset.html

How to Reset EPSON L455 Service Required on Youtube

– Video How to Reset EPSON L455 Service Required on YouTube, as of the current time, has received 3211 views with a duration of 3:21, taken from the YouTube channel: youtube.com/@GJRPrinterRepair.